6 common things you might be doing wrong with your table saw

Published: 5 years ago

Views: 4.8M / Comments: 1.3K / Like: 47.3K

By: "Steve Ramsey - Woodworking for Mere Mortals " Youtube Channel

Subscribers: 1.9M Total Views: 324.1M

Table saw relate videos find in this Channel:

Build a crosscut sled: essential table saw jig [ 06:24]

Views:1.1M / Like:29.3K

Make a table saw crosscut sled for your wood shop [ 09:12]

Views:945.7K / Like:4.4K

Watch this BEFORE turning on a table saw. The Table Saw Golden Rule. [ 08:41]

Views:182.3K / Like:7.7K

What's the single best table saw blade? [ 08:33]

Views:171.4K / Like:6.1K

A step-by-step guide to making your first table saw cuts. TABLESAW BASICS. [ 13:18]

Views:1.6M / Like:34K

Still getting ragged cuts? Try this. Essential woodworking table saw jig. [ 09:34]

Views:242.3K / Like:5.2K

Jig for edge jointing on a table saw | Mere Mini shop project [ 02:31]

Views:498.9K / Like:8.6K

Summary:

This video talks about 6 common mistakes people make when using a table saw. Not knowing the difference between the workpiece and the cutoff piece: It's important to know which piece needs support. Usually, you want to provide support for the workpiece. When using a miter gauge, an exception is when using a stop block on your RIP fence to make repeated cuts on small pieces. Not supporting the workpiece correctly when using a RIP fence to cut a wide board: The workpiece should be on the side between the blade and the fence. Don't guide the sheet from the cut off side. Using only one push stick: You need two push sticks, one to push the lumber forward and the other to keep the wood pressed downward and against the fence. Not using a push block: A push block is a great way to ensure an accurate cut. You can make one yourself with a scrap of plywood. Cranking down the nut on the arbor too tight: When you're installing a blade, just crank down the nut until it stops. You don't need to overtighten it. Not supporting the long side of the board: The basic rule is to support the long side of the board, not the short side. If the board seems to want to wobble, use your miter gauge instead.