How to Make Half-Lap Joints on a Table Saw | Tricks of the Trade

Published: 7 years ago

Views: 347.5K / Comments: 95 / Like: 3.8K

By: "Popular Woodworking " Youtube Channel

Subscribers: 261K Total Views: 29.3M

Table saw relate videos find in this Channel:

Testing the new Bosch Reaxx Table Saw [ 02:13]

Views:85.6K / Like:359

Carve a Chair Seat on the Table Saw with Mario Rodgriguez [ 17:51]

Views:192.7K / Like:1.6K

The Table Saw Fence: Making a Tall Fence and Cutting Rabbets [ 12:52]

Views:28.2K / Like:123

Table Saw Skills: Make a Small Cove Moulding [ 08:54]

Views:22.8K / Like:129

Mortise and Tenon Furniture: Tenons on Table Saw [ 05:32]

Views:393.3K / Like:1.3K

Choosing Push Sticks for the Table Saw [ 05:49]

Views:38.2K / Like:388

How Tight Should the Nut on Your Table Saw Blade be? | Tricks of the Trade [ 05:27]

Views:25.3K / Like:412

Choosing the Right Table Saw Blade for the Job [ 03:39]

Views:11.7K / Like:164

Summary:

This video is about how to make half-lap joints on a table saw. In the beginning of the video, the host talks about the importance of safety when using a table saw and removing the riving knife. He also mentions that you can use either a sliding table or a miter gauge. Next, he talks about the blade. He recommends using a combination blade, but says that a crosscut or ripping blade can also be used. Then, he demonstrates how to make an end lap. The two key things to measure are the shoulder width and the thickness. He uses an engineer's square and his fingertips to measure the shoulder width. To find the center of the board, he uses a straightedge rule. Once he has the measurements, he sets up the saw blade. He wants to make sure that the tooth is right up against the line he drew. He uses a trick to sneak up to the line by turning on the saw blade and slowly sliding the board over until the tooth touches the line. Then, he makes three passes with the saw blade to clear out the waste. He checks the depth of the cut and adjusts the blade as needed. Finally, he talks about how to make a half-lap on the corner. The same basic idea applies as with the end lap. Overall, this video is a helpful guide to making half-lap joints on a table saw. The host provides clear instructions and helpful tips.